Design by traininghaage

© ferdis-billardproducts.com

Instructions Cleaning - Sealing speed for threecushion balls • This guide is for balls that have been treated with the renewal creams No. 4-1 and havealready been sealed. • These balls after the game of pool with a water damp cloth afterwards and made special with the linen cloth, on the speed of the sealer was sprayed polish. You realize that this is no longer sufficient, so I clean the ball game with the special sponge plus special cleaner, with the renewal of 1 and sealer speed. • Take the special sponge and spray the special cleaner fed to the sponge. • Clean with a damp sponge special the entire surface of the billiard ball are visible to no more dirt. The cleaner removes the special sponge all previous residues such as grease, dirt, silicone, old cleaners, solvents, welding of the hands, chalk, burns or leather scraps at kicks and opens the pores of the seal. Then dry the billiard ball with the special cloth. • Now take her renewal cream No 1. Take the special cloth with the No. 1 and put it in the middle to even if you have not already done so with the first application of the renewal creams. Give each one approximately large drops the renewal cream No. 1 to the middle of the left and right side of the cloth. Put the ball on the center of one side to the drop and rub it slightly on the ball surface. Cover the cloth over the ball and rub and polish with regular rotations, the billiard ball. Make about about 15 to 20 rotations by hand. Then with flowing warm water to clean the pool balls. When renewing cream No 1 must billiard balls squeak properly if you clean them with running hot water doing. This is the sign that the billiard ball are really smooth again. Leave the cloth on high renewal cream. Us, you can use again next time. The creams are not bad. Dryness now the balls with the special cloth. • Now take the sealer speed and shake it thoroughly. Place the balls on a surface and spray the one billiard ball. Not too much sealer Apply! Less is more! Then wait about 15-20 seconds, until the vehicle is dry ethanol for the nanoparticles. Then the billiard ball turn around its axis, so you can spray the bottom half of the billiard ball well. For this, a tip: put simply the case of pool and snooker ball in the box and seal spray on the ball, just wait until they are dry and then put the lid on the box and turn it over. Then seal the balls from the other side as well. • For 100% of the billiard ball effect let dry for an hour. Do you play after sealing immediately without waiting for the effect is about 50%. • Now with the special polish dry cloth the billiard ball. (Do not put on the billiard ballpolishing or Shine!) Done! • When the balls subside in the game, just with the linen cloth on which was previously the sealer speed sprayed polish shortly. So that the balls are refrescht again and again have the effect of slip on the rail. • Mechanical impurities as kicks, jumping off the table or burns should be immediately during he game with the damp cloth cleaned off easily without special pressure of the sealed billiard ball. Polish with a cotton cloth loosely without pressure. • Depending unconsumed the billiard ball, the greater is the effect of the product. • The sealing speed with the slide effect lasts depending Billardtype, chalk the player's behavior, cleanliness of Spieker (washed hands?) And stress around 100 - 200 collisions.